1. Reduce of Concrete Permeability
For provision of a concrete resistant to the most aggressive environment, the most important property is the permeability.
Lower the ingress of movement of water or chemicals; lower the deterious reactions such as sulfate attack, reinforcement corrosion…
The reaction between Silica Fume and the calcium hydroxide, released as the cement hydrates, provides a dense impermeable pore structure. Although the total porosity of the Silica Fume concrete is similar to the OPC concrete the average pore size is much finer, conducting to a large reduction of permeability.
2. Improvement of concrete mechanical Performances
The Silica Fume reacts with the cement paste to form additional strong Calcium Silicate Hydrate (CSH) providing higher strength.
Silica Fume reduces bleeding and enhances the cement paste bond to the aggregates. Thanks to its pozzolanic effect (reaction with Ca(OH)2 ), and therefore to the strength improvement, Silica Fume can be used to reduce to the cement content of the mix.
In addition of the cost saving benefit, this will reduce the total heat of hydration and can improve the performances of the concrete in terms of chemical resistance.
3. Improvement of Concrete Sulfate resistance
Prior to develop the advantages of using Silica Fume to improve the concrete sulfate resistance, it may be interesting to highlight the basics form of sulfate attacks and the properties of sulfate resisting cement.
The use and deterioration of concrete in environments containing sulfates has led to the development of special sulfate resisting cements.
It has also spawned significant research into the use of supplementary cementitious materials to improve sulfate resistance.
The utility of Silica Fume for enhancing the resistance of concrete to sulfate attack has been widely studied.
Sulfate resisting cements (type V) have a low C3A content to minimize the risk off sulfate attack. However, this does not necessarily provide immunity:
- as certain sulfate react with hydrated lime and the calcium silicate hydrate the sulfate resisting cement provide less protection than expected.
- Low C3A cements are more susceptible to reinforcement corrosion attack.
The basic forms of sulfate attack are the following:
The reactive aluminates in the cement will react with the gypsum in cement during hydration. This process is harmless as the ettringite does not produce expansive forces and is stable in sulfate solutions.
If the quantity of reactive aluminates in the cement is too high, then their hydrate form will be available to react with sulfates after the cement has hardened.
This will produce expansive ettringite and cracking of the concrete.
Aluminate Hydrate + Calcium Hydroxide + sulfate + water => Ettringite.
The second principle cause attack is the acid interaction of sulfates ions and calcium hydroxide, causing gypsum formation.
Calcium Hydroxide + sulfate + water => Gypsum
It has been shown that the cation (calcium, Magnesium, Aluminium, Ammonium) of the sulfate salt affects the type and the severity of the attack.
4. Improvement of Reinforcement Corrosion Protection
In a marine structure, the performances of the concrete in terms of sulfate resistance must be taken into consideration for concrete design but the resistance to chlorides diffusion through the concrete is generally a main concern as well.
Some studies conducted in several countries proved that Type 1 cements (with high C3A content) blended with Silica Fume used in combination with a high range water reducer provide high durable performance against chloride-induced reinforcement corrosion and against sulfate attack.
The main reasons of this result can be summarize as follows:
- Silica Fume reduces the permeability of the concrete. Water and chemicals ingress are thus reduced.
- The ability of high C3A cement to complex with chlorides results in the formation of insoluble compound, able to reduce the mobility of free chloride ion to the reinforcement-concrete surface.
No comments:
Post a Comment